How to reset the Wiser Temperarture & Humidity sensor.

Using the Wiser Home app, you can remove the sensor from the Wiser system.

1. On the Home screen, tap .

   To wake up the sensor please press the function key.

2. Tap Devices > Temperature/Humidity Sensor > Delete.

   TIP: Additionally, you can remove the Sensor from the Wiser system by tapping on the Control tab Temperature/Humidity Sensor > Device settings > Delete.

3. Read the confirmation message and tap Ok to remove the sensor from Wiser system on the next screen.

   NOTE: Removing the smoke alarm from the app will reset the device. Once reset, the LED will blink amber, indicating that it is ready to pair.

If there is a problem while pairing or resetting the sensor please follow the steps below to reset the sensor to factory default manually.

1. Remove the sensor from the base plate by sliding it upwards.

2. Short-press the function key 3 times (<0.5 s) and then long-press the function key once (>10 s), the LED blinks red after 10 s, and then release the function key.

   Upon successful reset of the sensor, the LED stops blinking. Then, the sensor restarts and blinks green for a few seconds.

   NOTE:  After reset, the LED turns off to save the battery.